#include <introspected-doxygen.hpp>
Config Paths
ns3::ThompsonSamplingWifiManager is accessible through the following paths with Config::Set and Config::Connect:
-
"/NodeList/[i]/DeviceList/[i]/$ns3::WifiNetDevice/RemoteStationManager/$ns3::ThompsonSamplingWifiManager"
Attributes
-
Decay: Exponential decay coefficient, Hz; zero is a valid value for static scenarios
-
Set with class: ns3::DoubleValue
-
Underlying type: double 0:1.79769e+308
-
Initial value: 1
-
Flags: construct write read
-
MaxSsrc: The maximum number of retransmission attempts for any packet with size <= RtsCtsThreshold. This value will not have any effect on some rate control algorithms.
-
Set with class: ns3::UintegerValue
-
Underlying type: uint32_t 0:4294967295
-
Initial value: 7
-
Flags: construct write
-
MaxSlrc: The maximum number of retransmission attempts for any packet with size > RtsCtsThreshold. This value will not have any effect on some rate control algorithms.
-
Set with class: ns3::UintegerValue
-
Underlying type: uint32_t 0:4294967295
-
Initial value: 4
-
Flags: construct write
-
RtsCtsThreshold: If the size of the PSDU is bigger than this value, we use an RTS/CTS handshake before sending the data frame.This value will not have any effect on some rate control algorithms.
-
Set with class: ns3::UintegerValue
-
Underlying type: uint32_t 0:4294967295
-
Initial value: 65535
-
Flags: construct write
-
FragmentationThreshold: If the size of the PSDU is bigger than this value, we fragment it such that the size of the fragments are equal or smaller. This value does not apply when it is carried in an A-MPDU. This value will not have any effect on some rate control algorithms.
-
Set with class: ns3::UintegerValue
-
Underlying type: uint32_t 0:4294967295
-
Initial value: 65535
-
Flags: construct write read
-
NonUnicastMode: Wifi mode used for non-unicast transmissions.
-
Set with class: WifiModeValue
-
Underlying type: WifiMode
-
Initial value: Invalid-WifiMode
-
Flags: construct write read
-
DefaultTxPowerLevel: Default power level to be used for transmissions. This is the power level that is used by all those WifiManagers that do not implement TX power control.
-
Set with class: ns3::UintegerValue
-
Underlying type: uint8_t 0:255
-
Initial value: 0
-
Flags: construct write read
-
ErpProtectionMode: Protection mode used when non-ERP STAs are connected to an ERP AP: Rts-Cts or Cts-To-Self
-
Set with class: ns3::EnumValue
-
Underlying type:
-
Initial value: Cts-To-Self
-
Flags: construct write read
-
HtProtectionMode: Protection mode used when non-HT STAs are connected to a HT AP: Rts-Cts or Cts-To-Self
-
Set with class: ns3::EnumValue
-
Underlying type:
-
Initial value: Cts-To-Self
-
Flags: construct write read
TraceSources
-
Rate: Traced value for rate changes (b/s)
Callback signature: ns3::TracedValueCallback::Uint64
-
MacTxRtsFailed: The transmission of a RTS by the MAC layer has failed
Callback signature: ns3::Mac48Address::TracedCallback
-
MacTxDataFailed: The transmission of a data packet by the MAC layer has failed
Callback signature: ns3::Mac48Address::TracedCallback
-
MacTxFinalRtsFailed: The transmission of a RTS has exceeded the maximum number of attempts
Callback signature: ns3::Mac48Address::TracedCallback
-
MacTxFinalDataFailed: The transmission of a data packet has exceeded the maximum number of attempts
Callback signature: ns3::Mac48Address::TracedCallback
Size of this type is 432 bytes (on a 64-bit architecture).
The documentation for this class was generated from the following file: